Hot Dip Galvanizing of Irregularly Shaped Articles
Specifies the requirements for zinc coating (galvanizing) by the hot-dipping
process on iron and steel products made from rolled, pressed, or forged shapes
such as structural sections, plates, bars, pipes, or sheets 1 mm thick and
This Standard applies to both unfabricated and fabricated products such as
assembled steel products, structural steel fabrications, large hollow sections
bent or welded before galvanizing, and wire work fabricated from uncoated steel
This Standard applies to steel forgings and iron castings that are to be
galvanized separately or in batches.
This Standard does not apply to the continuous galvanizing of chain link fence
fabric, wire, sheet, and strip.
This Standard does not apply to pipe and conduit that are normally hot dip
galvanized by a continuous or semicontinuous automatic process.
The values stated in SI units are to be regarded as the standard. The values
in parentheses are Imperial units and are included for information only.